- Cập nhật
KỸ THUẬT SỬA CHỮA ĐIỆN THOẠI
- Cập nhật
- Cập nhật
- Cập nhật
- Cập nhật
- Cập nhật
- Cập nhật
- Cập nhật
- Cập nhật
THƯƠNG HIỆU TÀI TRỢ
- Cập nhật
- Cập nhật
- Cập nhật
- Cập nhật
- Cập nhật
THÔNG BÁO VÀ NỘI QUY
- Cập nhật
- Cập nhật
Please note that information about Xiaomi Redmi A2 EMMC Pinout may change according to time and specific product versions. Here is an overview of the Xiaomi Redmi A2 EMMC Pinout:
- VCC: Source voltage, usually 2.8V or 3.3V.
- VCCQ: Voltage source for EMMC control circuit.
- VCCQ2: Auxiliary voltage source for EMMC control circuit (if any).
- VCCQ3: Other auxiliary voltage source for EMMC control circuit (if any).
- CMD: Control command line for EMMC.
- CLK: Clock signal.
- DAT0: Data line 0.
- DAT1: Data line 1.
- DAT2: Data stream 2.
- DAT3: Data stream 3.
- DAT4: Data line 4 (if any).
- DAT5: Data line 5 (if any).
- DAT6: Data line 6 (if any).
- DAT7: Data line 7 (if any).
- RST: Special signal to reset EMMC (if present).
Note:
- When using Pinout information, care must be taken to avoid damaging important components.
- Use of this information should be made by persons experienced in the repair of mobile phones and similar devices.
Important note:
Pinout information may vary according to specific versions of Xiaomi Redmi A2 and may be adjusted by firmware updates. To ensure accuracy, please check the information from a reliable source or official technical documentation from Xiaomi.
Đăng ký:
Đăng Nhận xét (Atom)
image quote pre code