- Cập nhật
KỸ THUẬT SỬA CHỮA ĐIỆN THOẠI
- Cập nhật
- Cập nhật
- Cập nhật
- Cập nhật
- Cập nhật
- Cập nhật
- Cập nhật
- Cập nhật
THƯƠNG HIỆU TÀI TRỢ
- Cập nhật
- Cập nhật
- Cập nhật
- Cập nhật
- Cập nhật
THÔNG BÁO VÀ NỘI QUY
- Cập nhật
- Cập nhật
Following the full instructions below along with an image, you can easily bypass FRP or reset user data on your device through EasyJTAG Plus Box or any other tool.
1: You need to remove the back cover from the phone, remove the motherboard from the battery, fingerprint sensor and camera.
2: Remove the screws from the motherboard.
3: On the motherboard, locate the six eMMC pins (The pins are TxOp, TxOn, RxOp, RxOn). You need to cut through the steel shell to expose them.
4: Bring the UFI box and take the adapter out of it. You will see the exact same pins in the adapter I mentioned in the previous step.
5: Solder 4 pins: TxOp, TxOn, RxOp, RxOn with jumper between motherboard and adapter. Leave VCC and VCCQ for USB to power them.
6: Put the adapter inside the UFI box. Connect the box to the computer.
7: Connect the motherboard to the phone's battery. Then put the USB cable in the phone and connect it to the computer.
Đăng ký:
Đăng Nhận xét (Atom)
image quote pre code